Slope Profile Generation in GEOVIA Whittle

By

The way that GEOVIA Whittle generates angles are for each slope profile. This is done through the Slope Set Engine, which first converts the slope requirements into an inverted “cone” that defines the rock that must be mined to expose a point at the tip of the cone. At each bearing specified, this cone has the required slope. Between these bearings, the slope is interpolated.
If you have slopes that change more quickly than this, Whittle’s engines will detect it when they read the slope profile, and will report the minimum bearing difference required.

In the following example, let’s assume you have the requirement of the slope profiles and angles as follows:

Normally, you would create and apply slope profile as follows in Whittle.

 

However, these bearings and changes in slope will produce the following error in Whittle: “In sub-region 5 the slope changes too quickly for the change in bearing. The slope cannot change from 45.00 to 35.00 in less than 45.56 degrees.”

This is because the difference in bearing in this example needs to be more than 45.56 degrees.

To achieve the required profile in Whittle, you have to create an attribute in block model for “Zones” and subdivide the zones according to the required azimuth.

  • Assign zones according to profile and rock types

  • Import BM using zone option and use required slope angle on relevant zones

  • In slope type use option “Zone Number in Model file”

  • Finally, apply the required slope angles to the relevant zones and Whittle will complete the run.

For more GEOVIA Whittle tips, read:

0
Shoaib Zia

Shoaib Zia

Mining Knowledge Consultant, GEOVIA (CEng MIMMM) at Dassault Systèmes
Shoaib is a Chartered Engineer and Professional Member of IOM3 in the UK, with a Masters Degrees in Mineral Resource Management from the University of Exeter (UK) and Applied Earth Science from Technical University Delft (Netherlands). Shoaib's engagements include numerous geotechnical engineering, numerical modeling and mine planning projects both in the UK and overseas. Apart from GEOVIA software, Shoaib is also proficient in SIMULIA Abaqus.